Results 1 to 5 of 5

Thread: Any Tips On Installing Spindles?

  1. #1
    Registered User 16years&blazin's Avatar
    Join Date
    Feb 2002
    Location
    Summerville, South Carolina
    Posts
    838

    Thumbs up Any Tips On Installing Spindles?

    i am about to instal my spindles this weekend and i was wondering what kind of tips yall can give me., any help will be greatly appreciated. thanks
    Yahoo! Messenger = wintermc
    AOL Messenger = wintermc2

  2. #2
    Registered User GotAir19's Avatar
    Join Date
    Nov 2002
    Location
    florida
    Posts
    1,433
    dont for get to put the pins back in
    looking for 18s or 20s for my blazer that will tuk

  3. #3
    it fell? otter's Avatar
    Join Date
    Nov 2001
    Location
    Knob Noster Occupation: Pimping you out. Photoshop Diety.
    Posts
    4,933

    Remember to support the vehicle by the frame, and not the control arms.. keep one floor jack available. Get a chain to run through the springs, and get a spring compressor. Don't forget to tighten all of your bolts, and put the pins back in. :)

    AND GET AN ALIGNMENT AFTERWARDS...

  4. #4
    Box Luv BlazingDood13's Avatar
    Join Date
    Jan 2002
    Location
    Ft.Worth, Tx
    Posts
    2,068
    dont forget your ball joint spilter :bigthumb:
    www.DFWminis.com

  5. #5
    BlAzE iT uP! Eggleston69's Avatar
    Join Date
    Jul 2002
    Location
    Fresno,California
    Posts
    471
    will this drop ride good? 2 inch spindles, 1 inch coil, 3 inch leafs, 1 inch block, and belltech shocks all the way around?
    89 2dr Blazer
    -Engine- K&N FIPK, Poweraid Throttle Body Spacer, 700r4 w/ Corevette Servo and Stage 2 shift kit.
    -Exterior- Updated Chrome Grill, H4 Headlight kit, Clear Corners, Clear Bumper Lights, Euro's, Belltech 3/4, Eagle Alloys type 218 wrapped in BFG Rubber
    -Interior/Beats- !Coming Soon!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •