Results 1 to 3 of 3

Thread: Big problem with wheel fitment

  1. #1
    Large Member 2kBravada's Avatar
    Join Date
    Jan 2004
    Location
    Mount Vernon WA
    Posts
    63

    Big problem with wheel fitment

    ok guys,

    I was test fiting the ZR1's to make sure they fit, the fronts fit, but the knuckle shaft sticks out to far and the center cap can not be put on. Can these be cut down safely? Second the rear parking brake cable is not in far enough to clear the rim. the wheel hits it with about a half inch before it seats on the the rotor. any ideas?

    I'll be back with pictures
    I have MSN Messenger at ja.mcdonald

  2. #2
    2wd owning member bmxr4life87's Avatar
    Join Date
    May 2003
    Location
    Sapulpa, Oklahoma
    Posts
    1,584
    the cap can't be put on the front on any stock 4x4 or awd, u do have to trim the shaft down, and i'm not sure bout the back!!
    NEW RIDE 89 s10 std cab shortbed 2.5 5 speed 2WD slammed 6/5
    90 4x4 2dr, primer, 18's, 4.3, rollpan, 6/6 slam, SOLD
    The only ford i would drive is a courier!

  3. #3
    Large Member 2kBravada's Avatar
    Join Date
    Jan 2004
    Location
    Mount Vernon WA
    Posts
    63
    A little test fitting before the drop, thats going to happen wednesday! I should pull the knucle holding the shaft before I cut it, ehh







    this is how close the e-brake line goes to the stock wheel, my friend should be able to weld up a bracket! I hope
    I have MSN Messenger at ja.mcdonald

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •