Results 1 to 3 of 3

Thread: Problems using 95- tacoma front clip

  1. #1
    Registered User 84dime's Avatar
    Join Date
    Dec 2004
    Posts
    113

    Problems using 95- tacoma front clip

    Ok guys i am doing some research on front clips and i like the 95 on up tacoma front frame but i am wondering about problems. First i should say that my blazer will be on hydros this time so the stock front clip with cups would look kinda awkward. I also like the idea of rack and pinion. I do understand that they do not make drop spindles for these so i plan to "Z" it even more to make up for that. Now some questions-

    1- Does the tacoma frame have less travel then the s10, if so how much?

    2- How is the geometry of the tacoma front end?

    3- What are some of the pains going to be if i do this?

    Thank you for and comments and suggestions as long as they are helpful. -Josh
    -Practice does not make perfect,
    Perfect practice makes perfect...

  2. #2
    Doesnt look like this supernova's Avatar
    Join Date
    May 2002
    Location
    baton rouge, la
    Posts
    6,558
    your best bet is to check out a yota, or ranger forum for any technical info on one of the frames. The yota clips are super popular on the i-beam rangers

  3. #3
    Registered User 84dime's Avatar
    Join Date
    Dec 2004
    Posts
    113
    Ya i created an account with one of the yota sites but you know most will not admit if something on their vehicle was poorly designed. -Josh
    -Practice does not make perfect,
    Perfect practice makes perfect...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •