Results 1 to 4 of 4

Thread: raising a Beltech drop?

Hybrid View

  1. #1
    Registered User
    Join Date
    Jan 2011
    Location
    Mustang ,OK
    Posts
    3

    Question raising a Beltech drop?

    I just bought an '83 that already was lowered 3" using Beltech. I was considering lifting the rear a couple/few inches. Would it be as simple as replacing springs with the factory ones or am I overlooking other issues?

    Thanks
    Bill

  2. #2
    Registered User Tuknduces's Avatar
    Join Date
    Nov 2010
    Location
    Ohio
    Posts
    375
    If that is all that's done then yea. If it has only drop leafs with no blocks than putting in stock leafs will lift it back up. The only other thing is if the shocks were replaced for the drop. You might have to put in new shocks also.
    Drop,Drag,TuKnDuCeS

  3. #3
    Registered User
    Join Date
    Jan 2011
    Location
    Mustang ,OK
    Posts
    3

    Question

    It does have blocks. Can I just use smaller blocks to get the lift I need?

  4. #4
    Registered User Tuknduces's Avatar
    Join Date
    Nov 2010
    Location
    Ohio
    Posts
    375
    Take Out The Blocks Put In New U Bolts If Needed And See How Far The Rear Lifts Up. Depending On The Size Of Block You Can Always Put In A Smaller One. I Know They Make A 4'' Angled,3'',2'',1''. I'm Not Sure If They Make Any Other Size..
    Drop,Drag,TuKnDuCeS

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •